User’s Guide for
®
1:20 Nascar RC
#9 Kasey Kahne
Model No.
9507-9
What is included with
1:20 Nascar® RC
Functions of Buttons
LEFT SWITCH ON TRANSMITTER:
Switch up to drive the vehicle
forward. Switch down to drive
the vehicle in reverse.
TRIM SWITCH CONTROL: The
trim switch is located on the
underside of your vehicle. This
is used to align the wheels for
consistent straight line driving.
Switch left or right to align the
wheels.
RIGHT SWITCH ON TRANSMIT-
TER: Switch left to steer the
vehicle left. Switch right to
steer the vehicle.
ON/OFF SWITCH: Switch to turn
the transmitter on or off.
Manual
4
5
Another radio controlled
vehicle using the same fre-
quency is operating near
your vehicle, or a CB is
being operated nearby. If
that is the case, you should
race other vehicles that use
different frequencies or
channels, or move away
from your location until
there is no more interfer-
ence.
If your 1:20 Nascar® RC
drives slowly or appears to
be losing power, please
check the following poten-
tial causes:
Trouble-
shooting
How to Play
To begin, insert the
Maneuver both control
switches to turn your 1:20
Nascar® RC in any direc-
tion you would like.
antenna wire through the
hollow tube. Avoid pulling
the wire too tight. The wire
is on the top of your 1:20
Nascar® RC. Tie a knot on
top to secure.
If your 1:20 Nascar® RC
doesn’t move, please check
the following potential
causes:
To maneuver the auto
forward, turn the right
switch to the right and flip
the left switch up.
1. The POWER switch is
turned off. If that is the
case, turn the POWER switch
on.
2. Your 1:20 Nascar® RC
is too far away from the
controller. If that is the case,
bring your 1:20 Nascar® RC
closer to the controller.
Turn the switch to the ON
position for power.
To turn the auto left
while driving in reverse use
the switches as follows: flip
the right switch left and flip
the left switch back.
In a clockwise direction,
screw the antenna into the
cavity located at the top of
the transmitter.
Use the control switches
on the transmitter to drive
your 1:20 Nascar® RC. The
switches allow you to drive
it forward, back, left and
right. You can also honk the
horn and lift the doors up.
3. The metal tab in the
battery cartridge is flattened
and not touching the batter-
ies installed. If that is the
case, lift up the metal tab so
it touches the tip of the bat-
tery.
1. There are weak batter-
ies in the transmitter. If that
is the case, replace with
new batteries.
Tip
•
Check the wheel mecha-
nisms for lint, thread, hair
or dust frequently. This
ensures the wheels move
freely and that the motor is
not stressed.
2. There is strong inter-
ference in the surrounding
area. If that is the case, you
should move to a better
location to drive your 1:20
Nascar® RC.
You can control your
1:20 Nascar® RC’s turns
with the control switches.
If you lose control of your
1:20 Nascar® RC, please
check the following poten-
tial cause:
Changes or modifications to this unit not expressly
approved by the party responsible for compliance could
void the user’s authority to operate the equipment.
7
6
Special Care & Handling
Avoid rough handling such as bumping or dropping.
Avoid moisture and extreme temperatures. For
best results, use between the temperatures of 39º F and
100º F (4º C and 38º C).
Never drive your 1:20 Nascar® RC on a wet floor, on
sand, or in mud, rain or snow. These can damage it.
Be sure to remove the batteries from your 1:20 Nascar®
RC and transmitter when storing the product.
To protect your 1:20 Nascar® RC’s wheel mechanism
from lint, thread, hair and dust particle, you can use a
small brush, tweezers or tie a small bit of cloth to the
tip of a toothpick, etc., and wipe it off.
Caution
• Do not operate your 1:20 Nascar® RC in
•
•
thunderstorms.
• Do not touch the wheels when the switch is turned ON.
• Do not leave your 1:20 Nascar® RC or transmitter
near sources of heat or under direct sunlight for
long periods of time.
• Do not operate your 1:20 Nascar® RC near small
children.
• Do not drive your 1:20 Nascar® RC in busy
streets. Always choose a safe place to play.
•
•
•
•
•
Always keep your 1:20 Nascar® RC clean. Use a
dampened cloth to wipe off, and then wipe all the water
off with a dry cloth. Never use chemicals to clean your
1:20 Nascar RC.
Avoid holding the wheels when rotating. Holding them
will cause the electronic components to short-circuit,
overheat and cause malfunction.
8
9
BATTERY INFORMATION
90-Day Limited Warranty
•
•
•
•
•
•
•
Use alkaline batteries for best performance.
Use six AA batteries for your 1:20 Nascar® RC.
Use one 9-volt batteries for your transmitter.
Do not use rechargeable batteries.
EXCALIBUR ELECTRONICS, INC., warrants to the original consumer
that its products are free from any electrical or mechanical defects for a peri-
od of 90 DAYS from the date of purchase. If any such defect is discovered
within the warranty period, EXCALIBUR ELECTRONICS, INC., will repair
or replace the unit free of charge upon receipt of the unit, shipped postage
prepaid and insured to the factory address show at right.
Remove exhausted batteries from the unit.
Do not short circuit battery terminals.
The warranty covers normal consumer use and does not cover damage that
occurs in shipment or failure that results from alterations, accident, misuse,
neglect, wear and tear, inadequate maintenance, commercial use, or unrea-
sonable use of the unit. Removal of the top panel voids all warranties. This
warranty does not cover cost of repairs made or attempted outside of the fac-
tory.
To avoid explosion or leakage, do not dispose of
batteries in a fire or attempt to recharge standard
or alkaline batteries.
•
Be sure to insert batteries with the correct polarities
and always follow the toy and battery
manufacturers’ instructions.
Any applicable implied warranties, including warranties of merchantabil-
ity and fitness, are hereby limited to 90 DAYS from the date of purchase.
Consequential or incidental damages resulting from a breach of any applica-
ble express or implied warranties are hereby excluded. Some states do not
allow limitations on the duration of implied warranties and do not allow
exclusion of incidental or consequential damages, so the above limitations
and exclusions in these instances may not apply.
•
•
Remove batteries and store them in a cool, dry place
when not in use.
Always remove old and dead batteries from the product.
The only authorized service center in the United States is:
Excalibur Electronics, Inc.
th
13755 S.W. 119 Avenue
This device complies with Part 15 of the FCC Rules. Operation is subject to the follow-
ing two conditions: (1) this device may not cause harmful interference, and (2) this
device must accept any interference received, including interference that may cause
undesired operation.
Miami, FL 33186 U.S.A.
Phone: (305) 477-8080
Fax: (305) 477-9516
NOTE: This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to pro-
vide reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or tel-
evision reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the following
measures:
Ship the unit carefully packed, preferably in the original
carton, and send it prepaid, and adequately insured. Include a
letter, detailing the complaint and including your daytime
telephone number, inside the shipping carton.
If your warranty had expired and you want an esti-
mated fee for service, write to the above address, specify-
ing the model and the problem.
•
•
•
Reorient or relocate the receiving antenna.
PLEASE DO NOT SEND YOUR
UNIT WITHOUT RECEIVING AN
ESTIMATE FOR SERVICING. WE
CANNOT STORE YOUR UNIT!
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that
to which the receiver is connected.
•
Consult the dealer or an experienced radio/TV technician for help.
10
11
EXCALIBUR ELECTRONICS, INC.
13755 SW 119TH AVENUE
MIAMI, FLORIDA 33186 U.S.A.
PHONE: 305.477.8080
FAX: 305.477.9516
Play games
live at:
9507-9 (MA) 1-20 NascarRC Kasey Kahne 071906 V6
|